Planet KVM-210 Series User Manual page 16

The console section does not support hot plugging of PS/2 mouse and keyboard.
Step 8. Connect the mouse to the KVM Switch, via PS/2 or USB interface.
The console section does not support hot plugging of PS/2 mouse and keyboard.
Step 9. Install the Master KVM to the 3-in-1 cable (same as the cable for connecting the KVM to the PC)
in the middle of the Slave KVMs.
Step 10. Double-check all of the connections. You can check the color of keyboard and mouse
connector to make sure the keyboard and mouse cables go to the correct ports.
Step 11. Attach the power supply to the KVM unit and plug the other end into an electrical receptacle.
Now you will see the LED for Port 1 light up. Switch on your monitor.
It is not necessary to power down the whole system for installing a new PC or KVM
thereafter. All you need is to make sure that the new PC or KVM is OFF during the
installation. If the KVM powers down due to external Factors (such as power failure or
the power of the KVM is turned off), we recommend you to reinstall the whole system.
16
- -
8-/16-port Combo KVM Switch
IKVM/KVM-210 Series