Electronic Control Function; Abbreviation; Electric Control Working Environment; Outdoor Unit’s Digital Display Tube - KOREL M2OC-18HFN8-Q Service Manual

9.

Electronic control function

9.1 Abbreviation

T1: Indoor ambient temperature
T2: Coil temperature of indoor heat exchanger middle.
T2B: Coil temperature of indoor heat exchanger outlet(This sensor is located in outdoor unit)
T3: Coil temperature of outdoor heat exchanger
T4: Outdoor ambient temperature
T5: Compressor discharge temperature
Ts: Setting temperature

9.2 Electric control working environment.

9.2.1 Input voltage: 198V~264V.
9.2.2 Input power frequency:50Hz.
9.2.3 Indoor fan normal working amp. is less than 1A.
9.2.4 Outdoor fan. normal working amp. is less than 1.5A.
9.2.5 Four-way valve normal working amp. is less than 1A.
9.3 Outdoor unit's digital display tube
There is a digital display tube in outdoor PCB.
Digital display tube display function
 In standby , the LED displays "- -"
 In compressor operation, the LED display the running frequency,
 In defrosting mode, The LED displays "dF" or alternative displays between running frequency and
"dF"(each displays 0.5s)
 In compressor pre-heating, The LED displays "PH" or alternative displays between running frequency
and "PH"(each displays 0.5s)
 During the oil return process, The LED displays "RO" or alternative displays between running
frequency and "RO"(each displays 0.5s)
 In low ambient cooling mode, the LED displays "LC" or alternative displays between running
frequency and "LC"(each displays 0.5s)
 In forced cooling mode, the LED displays "FC" or alternative displays between running frequency and
"FC"(each displays 0.5s)
 When PFC module protection occurs three times within 15 minutes, the LED displays "E6" or
alternative displays between running frequency and "E6"(each displays 0.5s)
 In protection or malfunction, the LED displays error code or protection code.
26