JVC KD-X560BT Instruction Manual page 19

Installation
Ñ Removing the trim plate
1) Use the extraction key (accessory 4) to lever out
the four tabs (two on the top part, two on the
bottom part).
2) Pull the trim plate forward.
Ñ Removing the unit
1) Remove the trim plate by referring to step 1 in
"Removing the trim plate".
2) Detach the faceplate.
3) Insert the two extraction key (accessory 3) deeply
into the slots on each side, as shown.
3
4) Lower the removal tool toward the bottom, and
pull out the unit halfway while pressing towards
the inside.
✎
NOTE
• Be careful to avoid injury from the catch pins on
the extraction key.
5) Pull the unit all the way out with your hands, being
careful not to drop it.
4
1
2
Ñ Wiring harness connector function guide
Pin Color and function
A-4 Yellow
A-5 Blue/White
[1]
A-7 Red
A-8 Black
B-1/ B-2 Purple (+) / Purple/Black (–) Rear Right
B-3/ B-4 Gray (+) / Gray/Black (–)
B-5/ B-6 White (+) / White/Black (–)
B-7/ B-8 Green (+) / Green/Black (–)
Max. 150mA, 12V
[1]
• Speaker Impedance: 4-8 Ω
!
CAUTION
Before you connect the commercially available
ISO connectors to the unit, check the following
condition:
• Make sure that the pin assignment of the connector
matches with the JVC unit.
• Take extra notice of the power wire.
• In case battery wire and ignition wire are not
corresponding then change them accordingly.
• In case the car does not have an ignition wire, use a
commercially available interface.
Battery
Power Control
Ignition (ACC)
Earth (Ground) Connection
Front Right
Front Left
Rear Left
English | 19