Sony Walkman NWZ-ZX1 Help Manual page 244

Help Guide
Troubleshooting
WALKMAN
NWZ-ZX1
Back Back to Top
The computer does not recognize your "WALKMAN."
If the remaining battery power is low, charge the battery.
When you use your Walkman for the first time, or if you have not used the Walkman for a long time, it may take a
few minutes to be recognized by the computer. Check that the computer recognizes the Walkman after you have
connected it to the computer for about 10 minutes.
Make sure that the USB cable is connected to the computer properly and securely.
Use the supplied USB cable.
Your Walkman may not be recognized if connected via a USB hub. Connect the Walkman directly to the USB
connector on your computer.
Make sure that the USB connection is not turned off. Drag the status bar, and then tap [Turn on USB storage] on the
notification panel followed by [Turn on USB storage] then [ON].
Some devices or software may not recognize your Walkman when USB debugging is enabled. Tap
[Settings] - [ Developer options] - [USB debugging] and uncheck the box.
If the approaches listed above fail to resolve the issue, press and hold the
the RESET button with a pen or paper clip, etc. to reset your Walkman then try the USB connection again.
Related Topic
Charging the battery
Connecting to a computer by USB cable
Setting to automatically connect as USB storage
Resetting your "WALKMAN"
button for about 8 seconds or press
Go to Page Top
Print
, then tap
236