Use The Extender In Extender Mode - NETGEAR EX6130 Quick Start Manual

Use the Extender in Extender Mode

In extender mode, the extender repeats the signals from an existing WiFi
router or access point. Place the extender, supply power, make sure that
the extender is in extender mode, and connect it to your WiFi network.
Place the Extender and Supply Power
1. Place your extender in the same room as your WiFi router.
Proximity to the WiFi router is required only during the initial setup
process.
2. Plug the extender into an electrical outlet.
Wait for the Power LED to light green. This might take up to 60
seconds. If the Power LED does not light, press the Power On/Off
button on the side of the extender.
Check the Extender Mode
To make sure that the extender is in extender mode, check to see if the
WPS/Mode LED is solid green. If the WPS/Mode LED is off, press the
WPS/Mode button for more than five seconds.
When the extender is in extender mode, the WPS/Mode LED and Power
LED blink and then light solid green.
5