HDBaseT Wall Plate Receiver Table of Contents 1.0 Introduction 1.1 Block Diagram 2.0 Features 2.1 Package Contents 3.0 Setup 3.1 Installation 4.0 Configuration 4.1 Distance Mode Switch 4.2 LED Indicators 4.3 More on RS-232 Serial Connection and Operation 4.3.1 Power Management and RS-232 Operation 5.0 Troubleshooting 6.0 Specifications TRADEMARKS USED IN THIS MANUAL...
UHBX-R-WP 1.0 Introduction The UHBX-R-WP is a compact HDBaseT receiver in a wall plate. Perfectly suited for installations with shallow space between the wall and display, the receiver extends HDMI, IR and RS232 to 150m (500ft). The Receiver is powered via HDBaseT from the sender and no additional power supply is needed.
• • Made in the USA 2.1 Package Contents Qty (1) UHBX-R-WP Qty (1) 1m/3ft Type A USB to Mini-USB Cable Qty (1) Mud Ring for drywall installation Qty (1) User’s Manual Figure 2 – Mud-ring for drywall installation included in the package...
UHBX-R-WP 3.0 Setup 3.1 Installation The UHBX-R-WP is an HDBaseT™ receiver, meaning that a • compatible transmitter (sender) must already exist in the system. Hall Research provides various compatible transmitters, from economical video only, to video, plus RS232 for control, and IR extension. The Table below lists recommended senders and their characteristics.
HDBaseT Wall Plate Receiver If IR Extension is required, connect compatible I.R. Emitter and detector cables to the respective 3.5 mm connectors. Recommended IR emitter: p/n CIR-EMT and IR detector cable: p/n CIR-DET-P2. 4.0 Configuration As shipped, no user configuration is needed for extending HDMI video. By default the length of CAT6 cable plugged to the input can be as long as 150 meters (500 ft).
Direction Input Output The UHBX-R-WP supports bidirectional RS232 and communicates with a host through its HDBaseT input at a baud rate ranging from 110 thru 115200. 4.3.1 Power Management and RS-232 Operation By default “Power Management” is turned on. This means that if there is no video being extended, after some time, the system will place it’s HDBaseT...
The UHBX-R-WP does have a wakeup on RS-232 function so even if it is in low power mode, it will wake up and go into full power mode if it detects RS- 232 data coming through.
Page 10
UHBX-R-WP Make sure the display is compatible with the video source by connecting them directly. Make sure that the UTP or STP cable meets the requirements. Never use low-skew cable for digital video extension. We recommend using CAT6 or CAT6a.
HDBaseT Wall Plate Receiver 6.0 Specifications Video Standards DVI (single link) and HDMI (compliant with HDMI 1.4 and 2.0 video specifications including 12 bit color depth, 3D video and 4K/30 or 4K/60 4:2:0) Signal type TMDS Connectors Locking HDMI Resolutions DVI signal VGA (640x480) thru WUXGA (1920x1200) HDTV signal...