Table of Contents
Advertisement
Installing
Reattach the cover (Figure A).
1.
Firstly screw the two bottom screws followed by the two top
2.
screws (Figure B).
$
Refit the oven door.
3.
Once the glass panels have been correctly fitted, the oven is
ready to use.
Troubleshooting
Quite often, when there is a malfunction, it is usually a small
irregularity which is easy to rectify. Before contacting the
Technical Assistance Service, try to determine the cause of the
fault using the following table.
Troubleshooting table
Fault
Possible cause Solution/advice
The oven does
The fuse has
not work.
blown.
Power cut
The oven does
The timer is at
not heat up.
the 0 setting.
:
Risk of electric shock!
Incorrect repairs can be dangerous. Repairs can only be
carried out by qualified personnel from the Technical
Assistance Service.
%
Check the condition of the
fuse in the fuse box.
Check that the light in the
kitchen and other house-
hold appliances are work-
ing.
Turn the timer to the
setting.
Z
Changing the oven bulb
If the oven light bulb is damaged it must be replaced. Special
25 W, E14, 220 V-240 V heat-resistant light bulbs (to 300 ºC
temperature) can be obtained from the Technical Support
Service or in specialist shops. Only use this type of bulb.
:
Risk of electrical discharge and the resulting shock.!
Disconnect the appliance from the mains. Ensure that this is
turned off.
Place a dishcloth into the cold oven to avoid damage.
1.
Remove the glass protection by unscrewing it to the left.
2.
Replace the bulb with a similar bulb.
3.
Screw the protection glass back into place.
4.
Remove the dishcloth and switch the oven back on at the
5.
mains.
Protective glass panels
Damaged protective glass panels must be replaced. Protective
glass panels cay be obtained from the Technical Assistance
Service. Please quote your appliance's product number and
production number.
9
Hide quick links:
Advertisement
Table of Contents
