Antenna Connection / Alternative Solutions; Mounting; Connection; Switching On / Standby / Initial Setup - Hama CDR70BT Operating Instructions Manual

4.1 Antenna connection / alternative solutions

Note
• To optimise reception, the glass adhesive antenna
should be fitted such that it is in contact with the
vehicle body.
• If your vehicle's A pillar is covered with fabric or other
insulating material, fit the metal foil there anyway.
• Consult a local car workshop regarding the antenna's
contact with the vehicle body.
• Fit the antenna at the edge of the windscreen (preferably
on the passenger side) and connect the metal foil to your
vehicle's A pillar.
• Then connect the SMB connector of the antenna cable to
the antenna input (14) of the adapter.
Note
• The included glass adhesive antenna can be replaced
by an alternative antenna solution.
• The existing vehicle antenna can continue to be used
with an adapter.
• Consult a car workshop or visit www.hama.comfor
suitable accessories.

4.2 Mounting

Warning – Risk of injury
• Take care that components such as airbags, safety
areas, controls, instruments, etc. and visibility are not
blocked or restricted.
• Do not allow yourself to be distracted by the product,
for example when driving a vehicle or operating sports
equipment. Always pay attention to the surrounding
traffic and your environment.
Note
• Before mounting the holder, check the installation
options in your vehicle. If in doubt, consult the manual
for your vehicle or contact the manufacturer.
• Strictly avoid using undue force when using the
product or during installation.
A) Mounting to ventilation grille
• Fit the mounting adapter for ventilation apertures to the
back of the product. (Figure A)
• Now insert the device into the ventilation grille.
• The peg for the mount in the ventilation grille can be
turned 360° so that you can adjust alignment.
B) Mounting using the adhesive pad
Note – Mounting surface
Please note that the selected mounting surface (e.g.
dashboard) should be free of dust and grease. Use a
suitable cleaning agent from a specialised dealer to
clean the surface.
• Fit the mounting adapter with the adhesive pad to the
back of the product (Figure B).
• Clean the surface to which the adhesive pad is to be
affixed.
• Now remove the protective film from the adhesive pad
and mount the adapter on the chosen surface.

4.3 Connection

Note
• Only use original accessories (or accessories approved
by Hama), to prevent damage to the product.
• Connect the supplied USB charging cable to the USB port
(16) of the device.
• Connect the unused plug on the USB cable to a 12 V
socket of your vehicle.

4.4 Switching on / Standby / Initial setup

Switching on the product
• Press and hold [ ](2) for about 3 seconds to switch on
the device.
Switching off the product
• Press and hold [ ] (2) for about 3 seconds to activate
the standby mode.
Note
To switch off the radio completely, disconnect it from the
power supply.
6