Layout Of Ir Controller's Buttons; Work With The Menu, Control Through The Ir Controller - Elen NDC 57/4 R L20 User Manual

5.2 Layout of IR controller's buttons

5.3 Work with the menu, control through the IR controller

In the display mode, the clock does not accept any control codes from the IR controller except the code of the
SELECT button. That prevents inadvertent simultaneous setting of several clocks, if they are too close to each
other (within the range of the IR). When you push the SELECT button, the display will show its address in the
{Axxx} format, where xxx is a number from the range 0 to 126. The required clock is selected by entering its
three-digit address 0 – 9 buttons without the need to confirm. When a correct address is entered, {Menu} will
be displayed on the respective clock, which means that the clock is in the setting mode. If an incorrect address
is set or the address is not entered within 3 seconds, the display will move automatically into the standard
displaying mode. {Menu} will be displayed only upon entering the menu to confirm the correctness of the
previous steps, but is it not displayed when browsing in the menu.
Arrow buttons ▲ and ▼ are used for browsing in the menu. A selected submenu should be confirmed by the
OK button. When the browsing stops in a submenu, after 2 seconds the value of the displayed parameter and
its name will be displayed alternately (value for 0.5 sec / name for 1.5 sec). It is possible to continue with
browsing also in this mode, until the required parameter is found.
To change the value of a parameter confirm that parameter with the OK button – its value will be displayed
permanently and it is possible to modify it with numerical buttons. A digit that is being modified will blink. If the
value of the parameter is a non-numerical one (ON/OFF, decimal point, minus sign), use the ◄/► buttons to
switch to the required value. Confirm the new value by pressing the OK button. If the new value is not confirmed
within 7 seconds, a move one level up will occur (i.e. to the list of parameters) and the original value will remain
unchanged.
Digital clocks – NDC Series / User Manual v. 2.11
Button
SELECT
RESET
▲ up button
► right button
◄ left button
▼ down button
Colour
ESC
ESC to one level up
Select device
0 – 9
Enter digits
Switch between values, DP
◄/►
position, +/-
▲ Move up in the menu
▼ Move down in the menu
OK
Confirmation button
► Start
Pause
▐ ▌
■ Stop
Reset
7
Description of function
9