Table of Contents
Advertisement
7.3 Counting up/down (Counter)
Counting of the time up/down is is backed up and it remains active also when the clock is off (i.e. without
power supply) and irrespective of the state in which the counter was at the time of the switching off (active,
pause, ...). During the time in which the NDC clock was off, the relay output cannot be activated. If the clock
in the counter mode is switched off for a time that is longer than the time up to the end of the set limit, and the
activation of the relay output is enabled, when the power supply is resumed, the relay output will be switched-
on immediately.
8
RESET – RESTORING OF ORIGINAL VALUES {rSt}
({MEnu}→){SEt}→{ConF}→{rSt}
A reset will restore the original settings of the clock, see chapter 5.1 Table
After selecting the {ConF} item with the ▲ /▼ arrows, browse to the {rSt} and confirm by pressing the OK
button. During the setting of the defalut values, the display will go off for about 2 s and then it will show {donE}
and the clock will return automatically into the display mode.
9
SERVICE CENTER ADDRESS
In case of a display failure, please always contact your local dealer first.
Manufacturer:
ELEN, s.r.o.
Lubochnianska 16
080 06 Lubotice
SLOVAKIA
Tel.:
+421 / 51 77 33 700
+421 / 51 75 99 140
Fax:
+421 / 51 75 99 142
e-mail:
sales@elen.sk
http:
www.elen.eu
Digital clocks – NDC Series / User Manual v. 2.11
17
of the menu, default settings
.
19
Advertisement
Table of Contents
