Choice Of Input Coupling; Set The Input Reference - Velleman Panel Scope VPS10 Manual

Input coupling / input reference

Fig 12

Fig 13

CHOICE OF INPUT COUPLING

Press the 'MODE' button repeatedly until the

'INPUT' settings appear.

A short activation of the 'Up' button will switch

between ac (2) or dc (1) input coupling.

When measuring the "ripple" of a DC

voltage : put the input on AC to limit the

measurement to the AC component of the

signal.

Note:

•

At time bases of 1s/div and slower, the

input coupling is DC-only.

Keeping the 'Up' button pressed for a longer

time will internally connect the input to ground

and will keep the current readout as zero

reference for dc measurements.

VPS10 Panel Scope

Table of Contents