Kenwood KMM-BT505DAB Instruction Manual page 38

INSTALLATION/CONNECTION
Part list for installation
(A) Faceplate (×1)
(C) Mounting sleeve (×1)
(E) Extraction key (×2)
Basic procedure
1 Remove the key from the ignition switch, then disconnect the
the car battery.
2 Install the DAB antenna.
See "Installing the DAB antenna" on page 34.
3 Connect the wires properly.
See "Wiring connection" on page 33.
4 Install the unit to your car.
See the following "Installing the unit (in-dash mounting)".
5 Connect the terminal of the car battery.
6 Press B SRC to turn on the power.
7 Detach the faceplate and reset the unit within 5 seconds. (Page 3)
32
ENGLISH
(B) Trim plate (×1)
(D) Wiring harness (×1)
terminal of
Installing the unit (in-dash mounting)
Hook on the top side
Orientate the trim
plate as illustrated
before fitting.
Removing the unit
1 Detach the faceplate.
2 Remove the trim plate.
3 Insert the extraction keys deeply into the slots on
each side, then follow the arrows as shown on
the illustration.
Do the required wiring.
(Page 33)
Dashboard of your car
Bend the appropriate tabs to hold the
sleeve firmly in place.