Casio CDP-S350 User Manual page 16

■ To layer two tones
• Check to make sure that the U2 (Upper2) and
L (Lower) indicators are not shown on the display before
starting this procedure. If either indicator is displayed, press
co LAYER and/or cn SPLIT so they are not displayed.
1.
Press bq TONE.
• Confirm that the arrow mark () is to the right of the
U1 (Upper1) indicator.
2.
Use the bo dial to select a tone for the Upper1
part.
Example: 32 ELEC.PIANO 1
E . P i a n o 1
3.
Press co LAYER.
This displays the U2 (Upper2) indicator, with the arrow
mark () to the right.
4.
Use the bo dial to select a tone for the Upper2
part.
Example: 226 STRINGS
S t r i n
5.
Play something on the keyboard.
Both tones sound at the same time.
• Pressing co LAYER again will turn layer off.
Displayed
s
g
■ To split the keyboard between two different
tones
1.
Select the tone for the Upper1 part (page
EN-14).
• Press bq TONE and then use the bo dial to select the
tone you want.
Example: 312 FLUTE 1
F l u t e 1
2.
Press cn SPLIT.
This displays the L (Lower) indicator, with the arrow mark
() to the right.
3.
Use the bo dial to select the Lower part tone
you want.
Example: 60 VIBRAPHONE 1
V i b e s 1
4.
Play something on the keyboard.
This will sound the tones assigned to the left and right
side ranges of the keyboard.
VIBRAPHONE 1
Split point
F3
• Pressing cn SPLIT again will turn split off.
• If you turn on both layer and split, layering will be applied to
the right side range of the keyboard only.
Playing on the Keyboard
Displayed
FLUTE 1
EN-15