Table of Contents
Advertisement
Using accessories
The transmitter is compatible with a range of accessories. For detailed information on
using any of the accessories below please refer to the RD5100H
manual.
Transmitter signal clamps
When it is not possible to connect directly onto a pipe or cable, or induction mode is
unsuitable, a transmitter signal clamp may be used. The clamp is plugged into the output
of the transmitter and provides a means of applying a locate signal to an insulated live
wire. This is particularly useful with live insulated cables as it removes the need to disable
the power and break the line.
WARNING: Do not clamp around uninsulated live conductors.
WARNING: Before applying or removing the clamp around a power cable ensure
that the clamp is connected to the transmitter at all times.
Sondes, Flexrods and FlexiTrace
Sondes are battery powered transmitters that are useful for tracing non-metallic pipes.
They can be fixed to Flexrods to allow them to be pushed through pipes or conduits,
and some are suitable for blowing through ductwork. The RD5100H
a range of sonde frequencies, including those transmitted by flexiprobe
systems and flexitrax
crawlers.
™
For a detailed guide on locating sondes, please refer to the operation manual.
A FlexiTrace is a traceable fiberglass rod incorporating wire conductors with a sonde at
the end. It is connected to the output of the transmitter and is typically used in small
diameter, non-metallic pipes. The user has the option of locating the entire length of
the cable or choosing to locate only the tip of the cable.
Plug / Live cable connector
The plug connector is connected to the output of the transmitter and is used to put
a signal onto a line and trace it from a domestic mains plug to the service cable in the
street.
The live cable connector can be used to apply a signal to a live cable. Only suitably
qualified personnel should use this equipment.
O locator operation
2
O can detect
2
pushrod
™
12
Getting started with the RD5100H
To power on or power off the locator and transmitter, press and hold the On/Off
key for 2 seconds.
1.
Switch on the locator using the On/Off
2.
Once powered, the locator will automatically select the last mode used (Guidance
or Power mode).
3.
A momentary press of the Frequency
4.
In Guidance mode the following features are displayed on the screen:
•
Target Position Indicator
•
Compass
•
Numerical signal strength
•
Proportional left/right arrows
•
Active frequency icon
•
Depth
•
Current
•
Battery level indicator for 10 seconds after a key press.
5.
In Power mode the following features will be displayed:
•
Bar graph signal strength indicator
•
Numerical signal strength (percentage)
•
Numerical gain setting
•
Depth (metric or imperial, configuration dependent)
•
Battery level indicator for 10 seconds after a key press.
O
2
key.
key toggles between the two modes.
13
Advertisement
Table of Contents
