Advertisement
Wiring Instructions: Self Regulating GSP Panels to Battery.
1. Connect the ring terminal of black battery (-) wire to battery (-)
2. Connect ring terminal of red battery (+) wire to the battery (+)
The factory installed diode and fuse can be removed for advanced installations and users.
Removing these components will not void the warranty.
4-7 Connecting the GSP (Regulating is Required) Panels to 12V Battery Banks
MODEL: GSP-30, 40 & 55 solar panel connection using Ganz Charge Controller
Due to the GSP-30, 40 & 55W panels high peak voltage a charge controller is recommended to prevent the
battery from discharging through the solar array at night and overcharging of the battery during the day.
Panels utilizing charge controllers do not require blocking diodes. The recommended charge controller for a
single GSP-30, 40 & 55W solar panel is The GANZ 4.5A charge controller (GCC-4.5A Kit).
Wiring Instructions: GSP Panels to GANZ 4.5A charge controller (GCC-4.5A Kit) to Battery.
1.
Ganz 4.5A charge controller can be mounted in any position.
Ganz 4.5A can be mounted outdoors. Do not expose to ambient temperatures above 60˚C.
2.
3.
It is best to mount to a vertical surface and allow space for air flow through the controller.
4.
Connect the charge controller black wire (-) to the black 2 ft. battery cable using the blue wire nut.
5.
Connect the charge controller red wire (+) to the red 2 ft. battery cable using the blue wire nut.
6.
Connect the ring terminal of black battery (-) wire to the battery.
7.
Connect ring terminal of red battery (+) wire to the battery.
8.
Connect the black wire from the controller to the black (-) wire of the solar panel using the blue wire nuts.
9.
Connect the yellow wire from the controller to the red (+) of the solar panel using the blue wire nut.
6
Advertisement
