Download Print this page

Ganz GSP-06 General Installation & User Manual page 3

Eco-energy solar panels

Advertisement

Never touch the end of output cables with bare hands when the panel is illuminated.
3-3 General Maintenance Precautions
Ganz Eco-Energy Semi-Flexible Panels are designed for long life and require very little maintenance. If the
angle of the panel is 5 degrees or more, normal rainfall is usually sufficient to keep the panel surface clean.
Avoid prolonged exposure to saltwater as this may be a risk of permanent damage to the plastic
surface, which may cause reduced output power.
Panels should be cleaned periodically to remove salt deposits, dirt and seagull droppings.
Use water and a soft cloth or sponge. Mild, non-abrasive cleaners may be used.
Do not clean panels with any chemicals but rather clean with plain water
Once a year check the integrity of system wiring connections. Inspect for signs of damage to panel
surface or system cables.
Flat mounted panels may need to be cleaned more often.
3-4 General Installation Precautions
Do not touch the solar panel unnecessarily during installation. The panel surface may be hot. There is
a risk of burns and electric shock.
Do not unplug a connector if the system circuit is connected to an operating load.
Due to the risk of electrical shock, do not perform any work if the terminals of the solar panels are wet.
Use UV resistant materials, wire management hardware to secure cables. Drooping cables may
cause various problems, such as short or open circuits.
Panels should be firmly fixed in place to withstand all expected loads, including wind and snow loads.
4. Installation
4-1 Site Selection
Solar panels should be installed in a location where there is no constant shading.
In the northern hemisphere, panels should ideally face south, and in the southern hemisphere, panels
should ideally face north.
Take proper steps to maintain reliability and safety in applications where the panels are installed in
areas that have heavy snow, extreme cold or strong winds.
Avoid prolonged direct exposure to saltwater. Do not submerse in salt or fresh water.
When installing on a boat try to choose a location that will have sunlight regularly between 10:00 AM
and 3:00 PM.
3

Advertisement

loading

This manual is also suitable for:

Gsp-30Gsp-40Gsp-55Gsp-12