Advertisement
How to make Smart G4 HVAC Module works stand-alone:
A typical installation of Smart G4 HVAC Module need to be paired with one DDP to control
it.
In case there is no DDP in your installation, HVAC can also works stand-alone using other
interface such us IOS Application, Android App and HAC Software.
Here's the steps:
1. Your HVAC Module Firmware must be version v1.28 or above.
2. Connect an external Temperature Sensor as shown on the Diagram below.
3. Open your Smart Cloud Software and look for your HVAC Module.
4. On the HVAC tab, select Temperature Sensor.
5. Then, Select "Current module external temperature sensor"
www.smarthomebus.com
1
Advertisement
Table of Contents
Related Manuals for Smart-Bus G4
Summary of Contents for Smart-Bus G4
- Page 1 How to make Smart G4 HVAC Module works stand-alone: A typical installation of Smart G4 HVAC Module need to be paired with one DDP to control In case there is no DDP in your installation, HVAC can also works stand-alone using other interface such us IOS Application, Android App and HAC Software.
- Page 2 6. Save it. 7. You can go to the “Test” tab to test your HVAC if is working. If you done these steps, you are now ready to put it on the SQLite database: 1. Create a Zone 2. Go to HVAC table and enter the Subnet ID and Device ID of your HVAC Module (instead of DDP) www.smarthomebus.com...
- Page 3 3. Upload the database that you created to your device and test. www.smarthomebus.com...
Need help?
Do you have a question about the G4 and is the answer not in the manual?
Questions and answers