Offline Setup (No Internet Access); Step 1; Step 2; Step 3 - Dremel DigiLab 3D40 FLEX Quick Start Manual

OFFLINE SETUP (No Internet Access)

STEP 1:

Ensure the power switch is in the off position.

STEP 2:

STEP 3:

Spool
Holder
FIG. 1
Open
Close Filament Filament
Guide Tube
Install the build
plate holder
using the build
platform clips.
Twist spool door
counter-clockwise
to remove. Place
spool onto holder
with filament being
fed from the
bottom towards
the back. Thread
filament through
guide tube.

STEP 4:

Guide Tube Filament Extruder Intake

STEP 5:

Turn on the power switch and the printer will
guide you through the setup process.
WARNING
READ ALL OPERATING/SAFETY INSTRUCTIONS IN THE MANUAL AND
FAMILIARIZE YOURSELF WITH THE DREMEL 3D40 BEFORE SETUP AND USE.
FAILURE TO COMPLY WITH THE WARNINGS AND INSTRUCTIONS MAY RESULT
IN FIRE, EQUIPMENT DAMAGE, PROPERTY DAMAGE, OR PERSONAL INJURY.
2610053097 09/18
Insert filament
from the guide
tube into the
extruder intake.