Valcom V-9927A Quick Start Manual

DIGITAL MULTI-TONE GENERATOR
INTRODUCTION
The V-9927A was designed with ease of
installation and flexibility in mind. Connections
are by screw terminals located on the edge of
the PCB. The various options and tones are set
using option blocks located inside the enclosure
on the PC Board.
The V-9927A is a microprocessor controlled
multi-tone generator capable of producing a
variety of tone signals for various applications. It
is functional and backward compatible with the
previous V-9927.
Note: Double check all wiring as
connections to the unit are different.
This equipment has been tested and found to
comply with the limits for a Class A digital device
pursuant to Part 15 of FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference when this
equipment is operated in a commercial
environment. This equipment generates, uses
and can radiate radio frequency energy and if
not installed and used in accordance with the
instruction manual, may cause harmful
interference to radio communications. Operation
of this equipment in a residential area is likely to
cause harmful interference in which case the
user will be required to correct the interference
at his/her own expense.

SPECIFICATIONS

Power Requirements
-24VDC "B" Battery at 100mA
Nominal Input/Output Specifications:
Input Impedance:
Output Impedance:
Min. Output Load Impedance:
Audio Input:
Maximum Tone Output:
V-9927A
600 Ohms
Less than 4 Ohms
20 Ohms
0dBm nominal
>0dBm single tone
1
Operating Environment:
Temperature:
Humidity: 0 to 85% (non-condensing)
Dimensions & Weight

8.20 "H x 4.55 "W x 2.30 "D
(20.83cm H x 11.56cm W x 5.84cm D)

Weight: 1.5 lbs (0.68 kg)
INSTALLATION
Product is intended for wall mounting only.
When mounting, open enclosure and remove
circuit board. Screw back of enclosure to
backboard near the telephone system common
equipment. Snap circuit board back in place.
Both mounting holes must be utilized to
insure secure mounting of the unit.
Make connections and set tones, using option
blocks, as required for the specific application
Refer to Tone Table on page 2 for tone
descriptions.
Replace cover and plug in power supply.
Issue 6
0 to +50° C
947926