Power-Up Error Codes - ABB C1900 Operating Manual

2.1.1 Power-up Error Codes

If any of the power-up tests fail (see Fig. 2.2), error codes are displayed to identify the fault. Refer to Fig. 2.3 for error code
interpretations.
A––––F
–2–4––
Code
–
1
2
3
4
5
6
Code
–
A
C
d
F
Acknowledging Error Codes
Note. Acknowledging the Error Code clears the error state but does not rectify the fault.
After acknowledging the error, carry out the relevant action detailed in the above tables.
Configuration and battery-backed RAM errors
Calibration errors
Error
No error
Main board
Module in position 2
Module in position 3
Analog input and/or analog
output calibration is corrupt
Module in position 4
Module in position 5
Module in position 6
No error
Main program data stored in non-volatile
memory on main board is corrupt
Timer set up stored in battery backed RAM is corrupt
Maths set up stored in battery back RAM is corrupt
Totalizer set up in battery backed RAM has been corrupt
ACKNLG
ErrOrS
Fig. 2.3 Power-up Error Codes
Error
None
Check and correct program data
Check and correct data in
Check and correct data in
Check and correct data in
* Refer to the
or
2 SETTING UP...
Action
None
Power down and then up again.
If fault remains, contact the local Service
Organisation.
Action
Set Up Timer Page*
Set Up Maths Page*
Set Up Totals Page*
Advanced Software Manual
100. 3
200. 5
3