Model Assembly Continued
Propeller Installation
IMPORTANT: It is recommended to install the propeller after all system setups
are completed to reduce the chance of accidental propeller strike.
1. Install the spinner back plate (E), propeller (D) and collet (C) onto the motor
shaft (F). The propeller size numbers (10.5 x 8) must face out from the motor
for
correct propeller operation.
2. Tighten the collet by using a small screw driver or hex wrench inserted into
the small hole (Inset).
3. Align and install the spinner (B) with a small screw (A).
Control Horn and Servo Arm Settings
The table to the right shows the factory settings for the control horns and servo
arms. Fly the aircraft at factory settings before making changes.
NOTICE: If control throws are changed from the factory settings, the AR636
gain values may need to be adjusted. Refer to the Spektrum AR636 manual for
adjustment of gain values.
After fl ying, you may choose to adjust the linkage positions for the desired
control response. See the table to the right.
Optional Drop Tank Installation
Drop Tank
Slide the optional drop tanks (A) into the rails (B) on each wing.
Check the Center of Gravity with the drop tanks installed.
See the Adjusting the Center of Gravity instructions for more information.
D
C
B
A
Horns
Elevator
Ailerons
Flaps
Rudder
More control throw
E
F
Arms
Less control throw
A
B
7
EN