SWIT S-8U63 User Manual

SWIT@
S-8U63 Rechargeable Li-ion Battery Pack
USER MANUAL
SWIT Electronics Co., Ltd.
Characteristics
1. The battery pack is compatible with SONY PMW-EX1/3, F3,
and PMW-100/200 series cameras;
2, Display remaining power info in camera viewfinder;
3. 4-step LED power indicators;
4. D-tap DC output socket;
5. 5V/1A USB DC output socket for cell phone charging;
6. Build-in multiple protective circuit design.
Caution
1. The battery pack is not fully charged when it is purchased .
Charge the battery before use.
2. Use SWIT charger or the chargers recommended by SWIT.
3. Never attempt to open the battery pack.
4. Keep the battery pack terminals clean.
5. Never short-circuit the battery pack terminals .
6. Never expose the battery pack to rain , fire or moisture.
7. Never expose the battery pack to temperature above 60°C.
8. Avoid strong mechanical shock.
9. The battery pack may become warm in use or while being
charged . This is
norm~
_ _
~-
10. Fully charged battery pack will discharge naturally and please
use it as soon as it gets charged .
11 . At low temperature, the running time of battery pack usually
decreases.
12. The internal impedance of battery pack will be greater at low
temoerature . which mav cause the automaticallv circuit cutting .
Charging
The battery pack can be charged by SWIT S-3602U or SONY
BC-U1 charger via bottom terminals, or charged by SWIT
portable charger S-301 OB via D-tap DC socket.
The battery pack should be charged with in a temperature range
ot 0-40°C
LED indicator
1. The four-step LEDs indicate the remaining capacity when
press the power check button .
2. The indicator may not be accurate when the battery is
powering on the camera .
3. When only one LED indicates, please charge the battery as
soon as possible .
Power check button
100'Mi7S„5°"251ft
••••
D-tap DC socket
Tel: +86-25-85805753
Fax: +86-25-85805296
http://www.swit.cc
E-mail: contact@swit.cc
The D-tap DC socket can be used as 14.4V DC output or SWIT
S-301 OB charging input.
1. Open the rubber cover and plug in D-tap lead to DC output or
eh arge.
2. Close the rubber cover when disconnected, to keep the socket
away from dust.
14.4V D-tap DC output
Or S-301 OB charging input
USB power output
The battery offers a 5V/1A USB power output socket, for
charging cell phones.
1. Open the rubber cover and plug in USB lead;
2. Connect with the device to be charged;
3. Press the power
eh~~
button to switch on the USB charging
4. When USB charging finished , close the rubber cover to keep
the socket away from dust.
USB output socket
Remark: Most cell phones, mp3 players of 5V/1A charging are
supported , anyway, some of the PAD devices of 5V/2A can not
be charged. During charging, it won 't stop if the power check
button is pressed again.
Storage
Please keep in cool , dry and clean place .
Specifications
Model S-8U63
Nominal voltage
14.4V
Capacity
63Wh, 4400mAh
Pins 50W, 3.5A
D-T AP Socket
30W, 2A
MAX output
USB socket 5W (5V / 1A)
Total 50W, 3.5A
Applicable camera
SONY PMW-EX1/3/F3
PMW100 /200
Dimension 42x70x96mm
Mass
403g