Page 1
JA34-001 Universal Radio Adapter Installation and Operating Manual Rev. A Jupiter Avionics Corporation 1959 Kirschner Road Kelowna BC Canada V1Y 4N7 Tel: 778-478-2232 Toll-Free: 855-478-2232 www.jupiteravionics.com...
Page 2
All rights reserved Jupiter Avionics Corporation (JAC) permits a single copy of this manual to be printed or downloaded for the express use of an installing agency. Any such electronic or printed copy of this manual must contain the complete text of this copyright notice.
The JA34-001 Universal Radio Adapter allows the aircraft audio management system access to a non-aviation radio. The JA34-001 provides fully isolated audio signal paths to and from the radio to allow a noise-free installation. Microphone biasing and artificial sidetone generation are selectable for radios without them.
4 x 10-32 fasteners ≤ 2.5 mΩ Bonding Installation kit part number INST-JA34 1.4.3 Flammability of Materials The JA34-001 complies with the requirements of RTCA/DO-160G Sec 26.3.3 "Flammability", through equivalent flammability testing of materials and the Small Parts Exemption. Rev A Page 3...
Introduction This section contains unpacking and inspection procedures, installation information, and post-installation checks. Continued Airworthiness Maintenance of the JA34-001 is on condition only. Scheduled inspection and/or periodic maintenance of this unit is not required. Unpacking and Inspecting Equipment Unpack the equipment carefully. Check for shipping damage and report any problems to the relevant carrier. Confirm that the Certificate of Conformance is included.
2.4.2 Mechanical Installation The JA34-001 can be mounted in any attitude and location with adequate space and sufficient clearance for the connector and wiring harness. It requires no direct cooling. 2.4.3 Post Installation Checks 2.4.3.1...
A standard unit is shipped from the factory with all internal adjustments configured to the default levels shown in bold on the JA34-001 Settings page. At installation, it may be desirable to change some of these settings to suit the local operating environment.
Page 10
2.6.3.2 JA34-001 Universal Radio Adapter Adjustments (Blue block) The blue block refers to the adjustments and settings for the JA34-001 Universal Radio Adapter. Receive Input The level of the RECEIVE INPUT can be adjusted from 1.50 to 10.00 Vrms. (Default 7.75 Vrms) Artificial Sidetone The Artificial Sidetone may be selected as On or Off.
2.6.4 Aircraft Audio Systems List This is a list of Aircraft Audio Systems, and shows the configuration information that will be added to the JA34-001 Settings page. If it is desirable to add other Audio systems, click on the Aircraft Audio Systems List. A new audio system and its parameters can be added by clicking on (the ‘New Aircraft Audio System' button).
JA34-001 Universal Radio Adapter SECTION 3 – OPERATION Introduction The JA34-B001 Universal Radio Adapter allows the aircraft audio management system access to a non-aviation radio. Operation The JA34-001 is a remote mount unit and has no user accessible controls. Rev A Page 9...
JA34-001 Universal Radio Adapter Installation Manual Appendix A - Installation Drawings Introduction The drawings necessary for installation and troubleshooting of the JA34-001 Universal Radio Adapter are in this Appendix, as listed below. Installation Drawings DOCUMENT JA34-001 Connector Map JA34-001 Interconnect...
Page 15
Connection to airframe ground should be made with 20 AWG wire. Length not to exceed 3 FT (0.9 M). Cable shields at the JA34-001 connector pins should be terminated to airframe ground using a tag ring P/N: MS27741-3 or equivalent.
Removed the existing [model] radio adapter and replaced with a Jupiter Avionics JA34-001 Universal Radio Adapter in [aircraft location]. Installed in accordance with the JA34-001 Installation Manual, Revision [ ], and AC 43.13-2, Chapters 2, and 3. The JA34-001 interfaces with existing aircraft radios per the Installation Manual instructions.
Page 21
Refer to the JA34-001 Maintenance Manual. 7. Removal and Replacement Information Refer to Section 2 of this manual - the JA34-001 Installation Manual. If the unit is removed and reinstalled, a functional check of the equipment should be conducted. 8. Diagrams Refer to Appendix A of this manual - the JA34-001 Installation Manual - for installation drawings and interconnect examples.