Troubleshooting - TEFAL IT34 Series Manual

TROUBLESHOOTING

Problems
There is no steam.
The steam flow is
low.
Water runs through
the holes of the
steam head.
The steamer takes
a long time to heat
and/or ejects white
particles.
The Press & Steam
accessory is crooked.
The Press & Steam
accessory detaches
while in use.
6
Possible causes
The appliance has not
been switched on.
The hose has been
obstructed.
There is no water left in
the water tank.
Your steamer has a build-
up of scale because it
has not been rinsed out
regularly or descaled.
The hose has been
obstructed.
There is condensation in
the hose.
Your steamer has a build-
up of scale because it
has not been descaled
regularly.
The Press & Steam
accessory has not been
assembled properly.
The Press & Steam
accessory has not been
rolled properly.
The Press & Steam
accessory was not locked
correctly in the hook.
Solutions
Check that the appliance has been
plugged in correctly. Press the On/Off
button.
The appliance will begin producing steam
after approximately 60 seconds.
Check that the hose is not bent or twisted.
Check that the steam head is not laying
down on the floor.
Switch off the appliance and fill the water
tank.
Follow the «easy descaling» process.
Check that the hose is not bent or twisted.
Never use the steamer in the horizontal
position. Hold the hose vertically
outstretched and wait for the condensed
water to return to the steamer.
Follow the «easy descaling» process
Reassemble the Press & Steam accessory
inside the integrated hanger.
Make sure it is properly hooked in place by
following the instructions.
Make sure the Press & Steam accessory
is always dry then rolled with care when
stored. Do not crease it for storage.
Make sure the Press & Steam accessory
handle is firmly locked in the hook. It
should not be moving horizontally or
vertically.
Make sure the 4 segments of the pole are
fully extended and that the 3 clips are
firmly locked.