Download Print this page
IHP Montebello Series Installation Instructions

IHP Montebello Series Installation Instructions

Decorative andiron kit for use with direct vent gas fireplaces

Advertisement

Quick Links

INSTALLATION INSTRUCTIONS FOR DECORATIVE ANDIRON KIT
FOR USE WITH DIRECT VENT GAS FIREPLACES
FIREPLACE MODELS: MDLX40, MDLX45, MDLX40-PV, MDLX45-PV, DRT63 40/45, DRC63 40/45, DRT63STE, LSM40ST AND LSM40ST-PV
KIT CONTENTS
2 ea. Andirons
4 ea. Thumbscrews (2 attached to each andiron)
1 ea. Instruction Sheet
TOOLS NEEDED
Phillips screwdriver
Montebello Series Andiron Kits
Cat. No.
Model
H2227
AKM-LSM
H2228
AKC-LSM
Classic Andirons
Figure 1
GENERAL INFORMATION
These decorative andiron kits are offered in two different attractive styles
as an enhancement to the firebox appearance.
If you encounter any problems, need clarification of these instructions
or are not qualified to properly install this kit, contact you local distribu-
tor or dealer.
Read this instruction sheet in its entirety before beginning the installation.
ALL WARNINGS AND PRECAUTIONS IN THE INSTALLATION INSTRUC-
TIONS AND CARE AND OPERATION MANUALS PROVIDED WITH THE
APPLIANCE APPLY TO THESE INSTRUCTIONS.
TURN OFF THE FIREPLACE AND ALLOW IT TO COMPLETELY COOL
BEFORE PROCEEDING.
Description
Andiron Kit, Mission
Andiron Kit, Classic
(2) provided
Thumbscrews
per Andiron
(both styles)
Mission Andirons
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
750183M
REV. B 01/2014
INSTALLATION INSTRUCTIONS
Step 1. If applicable, remove the mesh pull screens, as follows:
Lift up the left side of the screen rod and slide it to the LEFT until
the right side of the rod is disengaged from the hole. Slowly
remove the rod and firescreens from the fireplace. Set aside in
a safe location for later reinstallation.
Step 2. Remove the glass door assembly, as follows:
a. See Figure 2. While holding the top of the glass door frame in
place, use a Phillips screwdriver to remove the two (2) screws
securing the door frame to the two (2) door latches.
b. Carefully swing the top of the glass door frame outward (as
shown in Figure 2), and then lift the door assembly up and out
of its lower track.
c. Carefully set aside the glass door assembly in a safe location
(on a padded surface) for later reinstallation.
(2) Latch
Screws
Glass Door
Assembly
Front View fireplace model shown. Instructions
also apply to See-Through models.
Figure 2
HEARTH PRODUCTS
KITS AND ACCESSORIES
DECORATIVE ANDIRON KITS
(2) Door
Latches
1

Advertisement

loading

Summary of Contents for IHP Montebello Series

  • Page 1 Step 2. Remove the glass door assembly, as follows: a. See Figure 2. While holding the top of the glass door frame in Montebello Series Andiron Kits place, use a Phillips screwdriver to remove the two (2) screws securing the door frame to the two (2) door latches.
  • Page 2 NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE. IHP reserves the right to make changes at any time, without notice, in design, materials, specifications, and prices, and to discontinue colors, styles, and products. Consult your local distributor for fireplace code information.

This manual is also suitable for:

Akc-lsmAkm-lsm