Specifi Cations; Parts And Accessories - Simplicity Prestige Series Operator's Manual

SPECIFICATIONS
ENGINE:
27 HP Kohler
Make
Model
Horsepower
Displacement
Electrical System
Oil Capacity
CHASSIS:
Fuel Tank Capacity
Front Wheels
Rear Wheels
TRANSMISSION:
K71
Type
Hydraulic Fluid
Capacity
Speeds
@ 3400 rpm
Continuous Torque
Output
Drawbar Rating
Maximum Weight
on Axle
Power Rating
The gross power rating for individual gas engine models is labeled in accordance with SAE (Society of Automotive En-
gineers) code J1940 (Small Engine Power & Torque Rating Procedure), and rating performance has been obtained and
corrected in accordance with SAE J1995 (Revision 2002-05). Torque values are derived at 3060 RPM; horsepower values
are derived at 3600 RPM. Net power values are taken with exhaust and air cleaner installed whereas gross power values
are collected without these attachments. Actual gross engine power will be higher than net engine power and is aff ected
by, among other things, ambient operating conditions and engine-to-engine variability. Given the wide array of products
on which engines are placed, the gas engine may not develop the rated gross power when used in a given piece of power
equipment. This diff erence is due to a variety of factors including, but not limited to, the variety of engine components (air
cleaner, exhaust, charging, cooling, carburetor, fuel pump, etc.), application limitations, ambient operating conditions (tem-
perature, humidity, altitude), and engine-to-engine variability. Due to manufacturing and capacity limitations, Briggs & Strat-
ton may substitute an engine of higher rated power for this Series engine.

PARTS AND ACCESSORIES

See an authorized dealer.
26
Kohler
Command CV740S
27 @ 3600 rpm
44.2 cu in. (725 cc)
Alternator: 15 amp Reg.
Battery: 12 Volt, 500 CCA
64 oz (1,9 L)
Capacity: 4.0 Gallons (15,1 L)
Tire Size: 16 x 6.5-8
Infl ation Pressure: 12-15 psi (0,68-0,82 bar)
Tire Size: 24 x 12.0 -12
Infl ation Pressure: 6-8 psi (0,41-0,55 bar)
Hydrostatic Tuff Torq K71
10w 30 Premium Engine Oil
4.8 qt (4,6 L)
Forward: 0-7.2 MPH (0-11,6 km/h)
Reverse: 0-4.5 MPH (0-7,2 km/h)
410 ft-lbs (554 Nm)
440 lbs (200 kg)
728 lbs (330 kg)
MOWER:
Width of Cut
Number of Blades
Base Deck Platform
Cutting Height
Cutting Positions
DIMENSIONS:
Overall Length
Overall Width
Height
46" (116,8 cm)
54" (137,2 cm)
3
Side Discharge
1.0 - 4.0 in. (2,5 - 10,2 cm)
Infi nite
75" (191 cm)
42" (107 cm)
50" (127 cm)
www.simplicitymfg.com