Installing The Pad; Connecting The Air Supply - SGS SAT601 Owner's Manual

INSTALLING THE PAD

1. Rotate the bearing seat so that the aperture faces the tab of the set
plate.
2. Push the set plate forward so that the tab enters the aperture in the
bearing seat. The bearing seat will be held static.
3. Screw the sanding pad onto the bearing seat by hand and ensure it is
fully tightened. Release the set plate tab before the tool can be used.
FITTING THE SANDING SHEET
4. Peel off the back of the self adhesive sanding sheet and stick it to the
backing pad. Take care that it is positioned centrally.
5. IMPORTANT: Only use sanding sheets designed for use with this type
of 150mm dia sanding pad.
WWW.SGS-ENGINEERING.COM

CONNECTING THE AIR SUPPLY

Pour 2-3 drops of airline oil into the air inlet. This should be done regard-
less of whether or not a lubricated air supply is to be used.
Connect a suitable hose to the tool as shown using the airline connector
supplied with the tool.
If required, connect an in-line mini oiler to the tool.
A mini oiler helps to prolong the life of the air tool. Remove the oil fill
screw from the side of the mini oiler and fill with air-line oil
WARNING: COMPRESSED AIR CAN BE DANGEROUS. ENSURE THAT
YOU ARE FAMILIAR WITH ALL PRECAUTIONS RELATING TO THE USE
OF AIR COMPRESSORS AND COMPRESSED AIR SUPPLY.
If a mini-oiler is not being used, run a few drops of oil through the tool
before use. It can be entered through the inlet strainer or via the hose at
the nearest connection to the air supply.
Connect the other end of the hose to the compressor.
Turn on the air supply and check for air leaks. Rectify any found before
proceeding. PTFE tape may be useful for sealing threaded connections.
Your air tool is now ready for use.
PAGE 8 PAGE 9