Table of Contents
Advertisement
Menu Setup
Menu List
Menu items are classified as one of the following
categories:
• Basic items (01~ and 10~)
• Items about an optional board in the IN1 section on
the rear panel (40~)
Item number
Item
01
INPUT SELECT
02
REF SELECT
03
VIDEO STD
08
PASSWORD
11
FREQ BW
12
FEC RATE
14
IF FREQ
15
IF OUT LEVEL
16
CARRIER
41
IN1 SDI AUDIO
42
IN1 EMPHASIS
12
• Items about an optional board in the IN2 section on
• Items about the front panel (80~)
• Items about the saving and recalling functions (90~)
The parameters in bold print are factory settings.
Parameter
Function
IN1
Selects either or both IN1 or IN2 section input signals to be
IN2
transmitted from the IF OUT connector.
IN1&IN2
IN1: The input signals from the optional board in the IN1
section are transmitted.
IN2: The input signals from the optional board in the IN2
section are transmitted.
IN1&IN2: The input signals from both optional boards in the
IN1 and IN2 sections are transmitted.
EXT
Selects the reference signals.
IN1
EXT: Video signals from the REF IN connector
IN2
IN1: Video signals from the input connector of the optional board
in the IN1 section.
IN2: Video signals from the input connector of the optional board
in the IN2 section.
525
Selects the broadcasting standard for which the unit is set up.
625
525: 525 standard
625: 625 standard
OFF
Turns the password function on or off. When "ON" is selected,
ON 0000 0001
set the password.
:
OFF: The DSM-R1 outputs normal video/audio signals
FFFF FFFF
regardless of the password of the DSM-R1.
ON: Sets an 8 digits password. If the password of the unit does
not match that of the DSM-R1, no video/audio signals will be
output from the DSM-R1.
36 MHz
Selects the frequency bandwidth.
18 MHz
7/8
Selects the Forward Error Correction rate.
3/4
140 MHz
Selects the output carrier frequency of the IF OUT connector.
70 MHz
0dB..-10dB
Selects the output level of the IF OUT connector.
<-10dB
In 0dB..-10dB mode, the level can be set from 0dB to
-20dB
-10dB in 1dB steps. In <-10dB mode, the level can be set from
-10dB to -20dB, but the displayed parameter is <-10dB.
QPSK
Selects whether or not to modulate the IF output signals.
OFF
QPSK: Outputs QPSK modulated wave
CW
OFF: Outputs no IF signals
CW: Outputs continuous (non modulated) wave
SDI
Selects the digital audio input signals if the BKSM-T102 SDI
AES/EBU
Input Board is installed in the IN1 section of the unit.
SDI: Digital audio signals in SDI format
AES/EBU: Digital audio signals in AES/EBU format
OFF
Turns the audio emphasis function on or off if the BKSM-T103
ON
Analog Input Board is installed in the IN1 section of the unit.
the rear panel (50~)
Advertisement
Table of Contents
