Before Using The Bedwetting Alarm; Using The Bedwetting Alarm - Welcare WBA100 Instruction Manual & Warranty Information

Before Using the Bedwetting Alarm

• Check the product is intact. DO NOT use if broken.
• Ensure the product is fully charged. Refer to Charging the Bedwetting Alarm
instructions on page 11.
• Test the product first on a damp cloth. Turn the product onto the Vibration
Only or Sound & Vibration Mode via the mode switch. Clamp the sensor clip
onto the damp cloth. If the product is sounding and/or vibrating then the
product is working.
• Let the child experiment with the product before using at night time,
so they are not frightened by the noise.
If any abnormalities are detected, please contact our service centre:
In Australia - 1800 807 464
In New Zealand - 0800 523 583

Using the Bedwetting Alarm

1. Select which Mode you wish to use
via the mode switch.
2. Attach the product to the child's upper
arm. Insert the plastic hook into the
small loop of the arm band. Adjust the
tightness to ensure it fits snugly, but
comfortably (not too tight).
3. Pass the cord under the child's
pyjama top to avoid
strangulation risk.
8.
1
Welcare Stay-Dry Children's Upper Arm Bedwetting Alarm
3
5
2
4