Mazda 3 Smart Start Manual page 35

Master Warning Light
Low Fuel Level
Low Engine Oil Pressure
Power Steering Malfunction
Automatic Transaxle
Warning Light
Charging System
Malfunction
Door/Trunk/Tailgate Ajar
Low Washer Fluid Level
Warning Light
KEY Warning Light
KEY Indicator Light
Check Fuel Cap
Perform Maintenance
i-ELOOP Status
On: Power generation
Flashing: Pre-Charge Mode
LED Headlight
Electric Parking Brake
NOTE:
See Owner's Manual for
more details and explanations.
• Rotate the knob to adjust the brightness of the instrument cluster and other dashboard illuminations.
1
• Push to toggle between trip meter (A & B).
2
• When a trip meter is selected, push and hold to reset to zero.
• Push the knob for 1.5 seconds or more to change the speed units between km/h and mph.
3
DASHBOARD
ILLUMINATION/
DIMMER /
1
TRIP METER
2
ENGINE COOLANT TEMP LIGHTS
Since this vehicle does not use an engine
coolant temperature gauge, red and blue
engine coolant temperature lights are used
to indicate high and low coolant temperature.
RED
GREEN
(p. 40)
www.MazdaUSA.com
IMPORTANT:
Mazda Connect display setting
is set on "AUTO", the instrument
cluster and display may become
dimmer when the headlights are
on. If the display and instrument
cluster become too dim or too
bright when the headlights are
on, simply rotate the dimmer
knob located on your instrument
cluster to adjust the brightness.
Red Coolant Temp Light
Flashing: Engine is starting to run hot.
Drive slowly to reduce engine load.
On: Engine is overheating. Safely pull
over to the side of the road and turn
the engine off. Refer to the Owner's
Manual for more information.
Blue Coolant Temp Light
On: Engine coolant is cold and no warm
air is available for heater/defroster.
Off: Engine coolant is warm and
warm air is available for heater/
defroster. The light may stay on for a
few minutes after start-up when the
engine is cold, but the vehicle can
be driven with the light on or off.
When your
34