Federal Signal Corporation 154XST Installation And Service Instructions Manual
Federal Signal Corporation 154XST Installation And Service Instructions Manual

Federal Signal Corporation 154XST Installation And Service Instructions Manual

Strobe light for use in harsh environments/ hazardous locations

Advertisement

Quick Links

MODEL 154XST
INSTALLATION AND SERVICE INSTRUCTIONS FOR MODEL 154XST
STROBE LIGHT FOR USE IN HARSH ENVIRONMENTS/
HAZARDOUS LOCATIONS
2561762B
REV. B 210
Printed in U.S.A.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 154XST and is the answer not in the manual?

Questions and answers

Summary of Contents for Federal Signal Corporation 154XST

  • Page 1 MODEL 154XST INSTALLATION AND SERVICE INSTRUCTIONS FOR MODEL 154XST STROBE LIGHT FOR USE IN HARSH ENVIRONMENTS/ HAZARDOUS LOCATIONS 2561762B REV. B 210 Printed in U.S.A.
  • Page 2 I. GENERAL. The Model 154XST Strobe Light is a UL listed visual signal for hazardous and marine locations and has been investigated by UL as meeting Type 4X (water tight and corrosion resistant) enclo- sure requirements.
  • Page 3 The dome guard (Part #K8449090) may be used as an accessory. It is mounted on the 154XST using the two supplied #8-32 screws. Adjust the tension on the screws until the dome guard is square with the housing.
  • Page 4 WARNING High voltages are present inside the light assembly. Wait at least 5 minutes after shutting off the power before servicing this unit. To change the flash tube, proceed as follows: 1. To remove the globe assembly, grasp the metal ring attached to the globe and turn it counter- clockwise.
  • Page 5 Manufacturer’s Representative. At this time a brief explanation of the service requested, or the nature of the malfunction, should be provided. Address all communications and shipments to: FEDERAL SIGNAL CORPORATION Industrial Systems Service Department 2645 Federal Signal Drive University Park, IL 60484-3167...
  • Page 6 290A4344 English A. Ground screw (green) B. 1/4-20 set screw C. 3/4-14 N.P.T. D. Field wiring E. Wrap power leads once around washer then pull through casting.
  • Page 7 290A4375 English A. New flash tube (K149122) B. Used flash tube tends to discolor in areas shown, and should be replaced. Industrial Systems 2645 Federal Signal Drive • University Park, IL 60484-3167 Tel: 708-534-4756 • Fax: 708-534-4852 Email: elp@federalsignal.com • www.federalsignal-indust.com...

Table of Contents