Page 1
® DSVII-SC User’s Manual Part Number 4040-00701-00 Version 1.11...
Page 2
Datastrip make no claims of suitability for any particular application. Datastrip will not be held liable for direct or indirect damages or other losses due to loss of data, reliability or performance issues relating to Datastrip-provided equipment or software.
Each unit is shipped with one Li-Ion battery installed, though disconnected. To enable the battery, you will need ® to remove the rear cover and plug the battery connector into the mating connector on the DSVII-SC • The battery is shipped fully charged, however, there is a small amount of self-discharge even when the battery is disconnected.
DSVII-SC User Manual, Version 1.11 ® Operation Startup Sequence: • To begin operation, depress and hold the power button on the front of the DSVII-SC ® unit. • Release the button when a single beep is heard. • Two additional beeps acknowledge that power has been activated. The keypad and LCD backlights will turn on.
Cleaning The LCD screen and fingerprint sensor may need periodic cleaning to ensure continued performance. Use only the Datastrip-approved cleaning-kit, to remove dirt, oils, grease, dust and foreign matter. To clean the LCD display or fingerprint sensor: Make sure the DSVII-SC ®...
USB ports, CF-slot (not visible) and 10/100 LAN port. NOTE: For developers, establishing an “ActiveSync” serial connection with a host-PC will require a Datastrip serial-port cable plus a null-modem cable. These are available through Datastrip Inc., Datastrip Ltd, or your authorized Datastrip reseller. The serial cable and null-modem cable is supplied free with Datastrip2D SDK.
Page 14
(This view is looking into the connector on the cable) WARNING: External equipment should connect only to the 9D-Subminiature male connector – NEVER directly to the 9-pin connector on the DSVII-SC ® unit. The following table details the signal configuration that exists when this cable is used on the COM1: port of the DSVII-SC ®...
Consult the dealer or an experienced radio/TV technician for help Note: The DSVII-SC is fully compliant with the requirements of FCC Part 15 and the EU Low Voltage Directive (72/73/EEC) for Conducted Emissions only when used with the Datastrip-supplied External Power Supply (DS P/N 3090-01225-02) and External Power Supply AC Linecord (DS P/N 3008-60163-01).
Datastrip will return all RMA equipment shipping-prepaid as well. Failure to follow this requirement will result in LENGTHY delays while your package is held by Customs. For parts, supplies and accessories, place your order through your authorized Datastrip reseller, or by contacting Datastrip Limited.