Advertisement
MODEL: PSF
FITTING INSTRUCTIONS FOR UNIVERSAL
PRECISION TABLE SAW FENCE
The PSF is a universal rip fence which can be fitted to a wide variety of table saws. It can be fitted to any
table where 3 x 8mm diameter holes can be drilled into the front face of the table, 20mm below the table
surface.
It can be retro-fitted to Charnwood models W619, W629 and W625.
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Charnwood PSF
Summary of Contents for Charnwood PSF
- Page 1 PRECISION TABLE SAW FENCE The PSF is a universal rip fence which can be fitted to a wide variety of table saws. It can be fitted to any table where 3 x 8mm diameter holes can be drilled into the front face of the table, 20mm below the table surface.
- Page 2 When choosing the position of the holes ensure that the rear face of the hole is flat and will allow access to tighten the nuts. Adjust the position of the holes as necessary. Drilling Template Having drilled the 3 holes, remove the end cap from the front fence rail and slide out the three M6 mounting bolts.
- Page 3 Undo the 2 wing nuts on the fence carrier until the fence extrusion can slide over the square head bolts as shown. Place the rip fence onto the front rail so that the face of the fence is up against the saw blade.
Need help?
Do you have a question about the PSF and is the answer not in the manual?
Questions and answers