Advertisement
INTRODUCTION
The Pot Press was designed for two functions; the installation of standard anchor pots
that are pressed in, and the removal of old pots that have been pressed in. It was
specifically designed to fit Wedge Clamp's 3-1/2" (89 mm) diameter pots, but can fit
other pots with the same features.
This manual press can replace the need for the traditional hydraulic pot press. It is a time
saving tool that is faster and lighter to work with. For drilling pot holes and anchor pot
layouts see Wedge Clamp's "Anchor Pot Installation Instructions"
POT PRESS KIT COMPONENTS:
Advertisement
