Vestil MT Owner's Manual

VESTIL MANUAFACTURING CORPORATION
2999 North Wayne St., Angola, IN 46703
Phone (260) 665-7586 • Fax (260) 665-1339
sales@vestil.com • Website: www.vestil.com
Ergonomic Solutions
Contents
Warning & Safety Instructions ......................... 1
Receiving Instructions ..................................... 1
Warranty .......................................................... 1
Ordering Replacement or Extra Parts ............. 2
Installation Instructions .................................... 2
Operating Instructions ..................................... 2
WARNINGS & SAFETY INSTRUCTIONS
Read owner's manual completely before operating unit!
• Not a personnel lift.
• Remove weight & disconnect power before working on unit.
• Use only maintenance parts supplied or approved by the
manufacturer.
• Never operate the lift unless you are watching it.
• Transport loads in the lowered position only.
• Don't continue to operate the control if unit is not moving.
• Consult factory before adding or performing any
modification to the original equipment.
RECEIVING INSTRUCTIONS
Every unit is thoroughly tested and inspected prior to
shipment. However, it is possible that the unit may incur
damage during transit. If you see damage when unloading
make a note of it on the SHIPPER RECEIVER.
Remove all packing and strapping material, inspect
for damage. IF DAMAGE IS EVIDENT, FILE A CLAIM WITH
THE CARRIER IMMEDIATLY! Also, check the unit size, type
of power unit, etc., to ensure the unit is correct for the intended
application.
WARRANTY
This product is warranted for 1 YEAR from date of
purchase to be free of manufacturing defects in material and
workmanship. The manufacturer's obligation hereunder is
limited to either providing replacement parts or repairing the
product, provided the product is sent prepaid back to the
factory.
This warranty does not cover normal wear of parts or
damage resulting from any of the following: negligent use or
misuse of the product, use or application contrary to installation
Revised 04-04
A company dedicated to solving ergonomic and material
handling problems since 1955 .
OWNER'S
MANUAL
MECHANICAL POST TABLE • MODEL MT
Mechanical Post Table Parts List ............. 3-4
DC Powered Post Table Parts List ........... 5-6
Trouble Shooting Guide ............................... 7
Electrical Diagram ........................................ 7
Instructions for Battery-Powered Units ......... 8
instructions, or disassembly, repair or alteration by any
person prior to authorization from a factory representative.
ORDERING REPLACEMENT OR EXTRA PARTS
Our company takes pride in using the finest available
parts for our equipment. We are not responsible for
equipment failure resulting from the use of unapproved
replacement parts. To order replacement or extra parts for
your equipment contact Customer Service at the factory.
In any correspondence with the factory please include the
Serial Number which is inscribed on the nameplate of the
piece of equipment. Use only the part numbers provided
in this Owner's Manual. When ordering parts for AC power
units please indicate the motor phase and voltage that the
equipment is operating on.
MECHANICAL POST TABLE
MODEL MT
21-126-103
E
N
G
L
I
S
H
E
S
P
A
N
O
L
1