Cpu_Fan1, Pump_Fan1, Sys_Fan1~4: Fan Connectors; Jtbt1: Thunderbolt Add-On Card Connector - MSI X299 RAIDER Quick Start Manual

CPU_FAN1, PUMP_FAN1, SYS_FAN1~4: Fan Connectors

Fan connectors can be classified as PWM (Pulse Width Modulation) Mode or DC Mode.
PWM Mode fan connectors provide constant 12V output and adjust fan speed with
speed control signal. DC Mode fan connectors control fan speed by changing voltage.
When you plug a 3-pin (Non-PWM) fan to a fan connector in PWM mode, the fan speed
will always maintain at 100%, which might create a lot of noise. You can follow the
instruction below to adjust the fan connector to PWM or DC Mode.
Important
You can switch between PWM mode and DC mode and adjust fan speed in BIOS >
y
HARDWARE MONITOR.
Make sure fans are working properly after switching the PWM/ DC mode.
y
Pin definition of fan connectors
PWM Mode pin definition
1 Ground 2
3 Sense 4

JTBT1: Thunderbolt Add-on Card Connector

This connector allows you to connect the add-on Thunderbolt I/O card.
Default PWM Mode fan connectors
CPU_FAN1/ PUMP_FAN1/
Default DC Mode fan connectors
SYS_FAN1/ SYS_FAN2/ SYS_FAN3/ SYS_FAN4
+12V
Speed Control Signal
1 FORCE_PWR
3
5
1
1
DC Mode pin definition
1 Ground 2
3 Sense 4
1
2
SLP_S3# 4
GND
Voltage Control
NC
SCI_EVENT
SLP_S5#
Overview of Components
27