Important Safety Instructions - ControlOMatic ChlorMaker IL Operating Instructions Manual

ChlorMaker IL is a semi-automated, salt water chlorine generation system specifically designed for portable spas
up to 1000 Gallons. ChlorMaker IL generates chlorine from a small amount of ordinary salt (Sodium Chloride,
NaCl) dissolved in the spa water. The amount of salt added is very small in relation to the volume of the water in
the spa. It's about 90% less concentration than ocean water and below the typical taste level of most humans.
The small addition of salt also benefits users by providing a softening effect on the water, leaving hair and skin feel-
ing smoother and healthier than with traditional sanitizing products. Only 2.5 cups of salt per 100 gallons of water
is all it takes for ChlorMaker to produce fresh, pure chlorine leaving your water clean and clear day after day.

IMPORTANT SAFETY INSTRUCTIONS

READ & FOLLOW ALL INSTRUCTIONS
SAVE THESE INSTRUCTIONS
When installing and using this electrical equipment, basic safety precautions should always be followed,
including the following:
WARNING: To reduce the risk of injury, do not permit children to use this product unless they are closely
supervised by at all times.
WARNING: Use ChlorMaker IL only according to these instructions. Any modification or misuse of this product
will void the warranty.
WARNING: Install ChlorMaker IL in accordance with all national and local electrical, plumbing, safety, and
other applicable codes.
WARNING: Connect ChlorMaker IL to a GFCI (ground fault circuit interrupt) or GFI (ground fault interrupt)
protected VAC power source only.
WARNING: Protect the power supply and outlet from exposure to the elements including direct sun, rain, snow,
condensation, etc.
WARNING: DO NOT use with extension cord. Injury may result.
WARNING: DO NOT insert objects into, or tamper with ChlorMaker IL's body in any way. Inserting metal
objects into the body may cause damage and void the warranty.
WARNING: DO NOT operate ChlorMaker IL if damaged in any way.
WARNING: DO NOT pull on the cord to disconnect the Power Supply from power source. Do not allow the
cord to rest on sharp edges or corners or to be walked upon. Do not drop, throw, or otherwise
rough handle ChlorMaker IL.
WARNING: DO NOT handle the unit during chlorine production (visible bubbling). Slight discomfort may be felt
in cuts, sores, or sensitive skin areas due to chlorine concentration and the electrolysis process.
Stop chlorine production by either removing ChlorMaker IL from the water by lifting the cord (do
not grasp the housing), or by unplugging the power supply from the power source.
WARNING: Unit must be disconnected from power source before performing any maintenance or
troubleshooting operations.
WARNING: Disconnect, remove, and store or ChlorMaker IL indoors when spa has been winterized or drained.
CAUTION:
Leave spa cover open at least 30 seconds to allow trapped gases to escape prior to use.
CAUTION: If unit is not working properly, or has been damaged in any way, contact technical support
immediately at 1-530-205-4520.
CAUTION: Measure water quality parameters and adjust if necessary prior to each spa use.
CAUTION:
Make sure all spa electrical components and power cords have been thoroughly inspected by a
licensed electrician prior to using ChlorMaker IL.
INTRODUCTION