Repair And Maintenance - Razor Dirt Rocket SX500 Owner's Manual

REPAIR AND MAINTENANCE

Turn power switch "OFF" before beginning repair or maintenance:
• Read the instructions
• Remove charger plug
• Turn the power switch off
Adjusting the Brakes
Tools required: 5 mm Allen wrench
1
To adjust brake cable play, thread
the brake lever adjuster in or out
1/4 to 1/2 turn until the desired
brake adjustment is attained. Most
adjustments are complete at this
step. If brake still needs further
adjustment, proceed to step 2.
Replacing the Fuse
3 Fuse boxes
1
Remove the seat fairing and
battery cover to locate the 3 fuse
boxes attached to the batteries.
• Secure the unit under repair
• Exercise caution around
exposed parts
2
If the brake has too much
slack, loosen the rear anchor
bolt with a 5 mm Allen wrench
and pull the brake wire tighter.
The distance of the brake wire
between the end of the cable and
the anchor bolt should be between
37 mm and 44 mm.
Amperage
number
2
Check all 3 fuses to see if the
fuse(s) have burnt out. Remove
any fuse that is damaged or burnt
out and replace with a new one of
equal amperage.
Note: Amperage is located on top
of fuse.
• Contact customer service if unsure
about any repair or maintenance
3
If the brake rotor is dragging on
the brake pads, use your fingers to
twist the caliper adjuster in either
direction until rotor is centered
between pads.
3
Close the fuse cover and reattach
the seat fairing.
8
WARNING: The brake is
capable of causing the electric motor
bike to skid the tire throwing an
unsuspecting rider. Practice in an open
area free from obstacles until you are
familiar with the brake function. Avoid
skidding to a stop as this can cause
you to lose control or damage the rear
tire.
Testing the Brakes. To use the
brakes, squeeze the levers to increase
the pressure on the brake. The brake
levers are fitted with a cable adjuster
to compensate for cable stretch and/
or to fine-tune the lever movement to
brake engagement. If brakes are not
engaging properly, follow instructions
for adjusting the brakes.
WARNING: To prevent
shock, please follow the instructions
accordingly and do not skip any steps.