Specifications - Sony DVCAM DSR-60 Brochure & Specs

Specifications

GENERAL
Power requirements
Power consumption
Operating temperature
Storage temperature
Operating humidity
Storage humidity
Mass 19 kg (41 lb 14 oz)
Dimensions 427 x 174 x 494 mm excluding external projections
(W x H x D)
Tape speed
Recording/Playback time Standard size:
Mini size:
Fast forward/Rewind time Standard size: Less than 3 min. w/PDV-184ME/184N
Mini size:
Search speed
When controlled via RS-422A:
When controlled via optional DSRM-10:
JOG mode:
SHUTTLE mode:
Digital slow mode:
JOG audio mode:
VIDEO PERFORMANCE
Band width (via analog component I/O)
Luminance:
Chrominance:
S/N ratio (via analog component I/O)
K-factor (K2T, KPB)
Y/C delay
AUDIO PERFORMANCE
Frequency response
2CH mode (48 kHz/16-bit):
4CH mode (32 kHz/12-bit):
Dynamic range
Distortion (THD + N)
SIGNAL INPUTS
<VIDEO>
ANALOG
Composite, 1.0 Vp-p, 75 Ω, sync negative
REF. VIDEO
(BNC x2, loop-through connection)
Composite, 1.0 Vp-p, 75 Ω,
VIDEO
(BNC x2, loop-through connection)
RGB/COMPONENT* (BNC x3)
*selectable
Y: 1.0 Vp-p, 75 Ω,
Y/R-Y/B-Y:
sync negative
R-Y/B-Y: 0.7 Vp-p, 75 Ω (75 %)
R. G (w/o Sync). B: 0.7 Vp-p, 75 Ω
1.0 Vp-p, 75 Ω, sync negative
G (w/Sync):
S-Video (DIN 4-pin x1)
1.0 Vp-p, 75 Ω, sync negative
Y:
0.286 Vp-p, 75 Ω (at burst level)
C:
©1999 Sony Corporation. All rights reserved.
Reproduction in whole or in part without written permission is prohibited.
Features and specifications are subject to change without notice.
All non-metric weights and measures are approximate.
Sony, Betacam SP, DVCAM, Digital BETACAM, EditStation, i.LINK, QSDI, and ClipLink are registered trademarks of Sony Corporation.
Distributed by
MK4197V6TC99MAR
DSR-80 DSR-60
AC 100 to 120 V, 50/60 Hz
140 W 85 W
5 °C to 40 °C (41 °F to 104 °F)
-20 °C to 60 °C (-4 °F to 140 °F)
Less than 80 %
Less than 90 %
18 kg (39 lb 10 oz)
(16 7/8 x 6 7/8 x 19 1/2 inches)
28.193 mm/s
More than 184 min. w/PDV-184ME/184N
More than 40 min. w/PDVM-40ME/40N
Less than 1 min. w/PDVM-40ME/40N
Search speed is up to 32 times,
forward and reverse.
Frame by frame to x2, forward and reverse
8 steps, still to x16 normal speed,
forward and reverse
3 steps, still, x1/5 and x1/10 normal
speed, forward and reverse
x1/30 to x1, forward and reverse
30 Hz to 5.0 MHz ±1.0 dB
5.75 MHz +0/-3.0 dB (Typical measurement)
30 Hz to 1.5 MHz +1.0/-5.0 dB
More than 55 dB
Less than 2.0 %
Less than 30 ns
20 Hz to 20 kHz +0.5/-1.0 dB
20 Hz to 14.5 kHz +0.5/-1.0 dB
More than 85 dB
Less than 0.05 %
—
sync negative
—
—
—
—
—
DIGITAL
SDI* (BNC x2, active-through connection)
Conforms to Serial Digital
Interface (270 Mbps),
SMPTE 259M
* Using Optional DSBK-120
(SDI Input/Output Board)
SDTI(QSDI) (BNC x1) Conforms to SDTI (270 Mbps),
SMPTE 259M
<AUDIO>
ANALOG
AUDIO - 9 dBu to 28 dBu,
600 Ω/10 kΩ, balanced
(XLR 3-pin female x4)
DIGITAL
110 Ω, balanced
AES/EBU
(XLR 3-pin male x2)
<TIME CODE>
Time Code In* (BNC x1) 0.5 Vp-p to 18 Vp-p, 3 kΩ,
unbalanced
* Using optional DSBK-130
(Time Code Input/Output Board)
SIGNAL OUTPUTS
<VIDEO>
ANALOG
REF. VIDEO (BNC x1) Black Burst:
Composite Sync*: 2.0 Vp-p, 75Ω, sync negative
Composite, 1.0 Vp-p, 75 Ω, sync negative
VIDEO 1/2 (SUPER) (BNC x2)
COMPONENT* (BNC x3)
*selectable
Y: 1.0 Vp-p, 75 Ω, sync negative
Y/R-Y/B-Y:
R-Y/B-Y: 0.7 Vp-p, 75 Ω (75 %)
0.7 Vp-p, 75 Ω
R. G (w/o Sync). B:
1.0 Vp-p, 75 Ω, sync negative
G (w/Sync):
S-Video (DIN 4-pin x1)
1.0 Vp-p, 75 Ω, sync negative
Y:
0.286 Vp-p, 75 Ω (at burst level)
C:
DIGITAL
SDI* (BNC x2) Conforms to Serial Digital Interface (270 Mbps), SMPTE 259M
* Using Optional DSBK-120 (SDI Input/Output Board) for DSR-80,
DSBK-100 (SDI Output Board) for DSR-60
SDTI(QSDI)* (BNC x1) Conforms to SDTI (270Mbps)
* Using optional DSBK-110 (QSDI Output Board) for DSR-60
<AUDIO>
ANALOG
4 dBu, 600 Ω loading, low impedance, balanced
AUDIO (XLR 3-pin male x4)
AUDIO MONITOR (RCA phono jack x1) -6 dBu, 47 kΩ, unbalanced
HEADPHONES (JM-60 headphone jack x1)
DIGITAL
2 to 7 Vp-p,110 Ω, balanced
AES/EBU
(XLR 3-pin male x2)
<TIME CODE>
Time Code Out* (BNC x1) 2.2 Vp-p, 600 Ω, unbalanced
* Using optional DSBK-130 (Time Code Input/Output Board)
REMOTE
RS-422A
TBC
CONTROL-S (SIRCS)
SUPPLIED ACCESSORIES
AC power cord (x1), RCC-5G Remote Control Cable (x1)
Operating instructions (x1), ClipLink Guide (x1)
*0dBu = 0.775Vrms
DSR-80 DSR-60
—
—
—
—
—
0.286 Vp-p, 75 Ω, sync negative
*When not adding sync to RGB output.
-16 dBu, 8 Ω, unbalanced
—
9-pin multi connector (x1)
D-sub 15-pin connector (x1)
Stereo mini jack (x1)
Printed in Japan