Cisco C880 M4 Firmware Update Manual page 2

Offline Firmware Update Procedure
Offline Firmware Update Procedure
Step 1 Log in with administrator privilege to the MMB web UI.
Step 2 From the Navigation bar, choose System.
Step 3 Power off the system (but do not disconnect the AC power).
Step 4 From the Navigation bar, choose Maintenance.
Step 5 Choose Firmware Update > Unified Firmware Update.
Step 6 Choose the firmware file.
Step 7 Click Update.
Wait for the firmware version check window to appear, which takes approximately 5 minutes.
Step 8 Click OK after confirming the firmware version.
The progress bar appears in about 1 minute.
• The time required to update the firmware for a one MMB configuration is about 70 minutes.
• For a one MMB configuration, wait about 5 minutes before logging into the web UI . The web UI is disconnected
during the firmware update.
Online Firmware Update Procedure
Before You Begin
Before starting the update, ensure that the system is in boot state and the OS is not running.
Step 1
Log in with administrator privilege to the MMB web UI.
Step 2 From the Navigation bar, choose Maintenance.
Step 3 Choose Firmware Update > Unified Firmware Update.
Step 4
Choose the firmware file.
Step 5 Click Update.
Wait for the firmware version check window to appear, which takes approximately 5 minutes.
Step 6 Click OK after confirming the firmware version.
The progress bar appears in about 1 minute. The time required to update the firmware for a one MMB configuration is
about 70 minutes.
This online firmware update procedure writes a new version of the firmware to the ROM device. To apply the
Note
new firmware to the system, power off the server and power it on again.
While the new firmware is being applied to the system, the web UI is disconnected. Wait about 5 minutes before logging
into the web UI.
Cisco C880 M4 Server Firmware Update Guide
2
Introduction