ATA KP-4F Coding Instructions Manual

99
s
C ODING INST R UCTI O NS F O R ATA
WIRELESS DI G I TAL KEYPA DS
WITH C ODE STOR E RX - 1 RE C EIVERS
M ULTI CHANNEL SYSTEM S
ATA Wireless Digital Keypad Transmitters are designed to provide operation of upto
four individual devices from the one transmitter. For example you may have remote con-
trolled gates, and remote controlled garage doors. You can eliminate the need to carry
several transmitters simply by programming in the ATA keypad transmitter as follows.
Matching Receiver & Keypad ( Multi Channel Operation)
1. Whilst the power is switched " on " to the opener or receiver you wish to
program, press and hold the "code set" button See Below.
2. While firmly holding in the code set button on the first device such as the front gates,
.press four ( 4) numbers on the keypad that you which to use as your P.I.N. , followed
immediately by pressing the channel
you wish to transmit on twice . (normally ch. 1)
for example , If you wanted the code 1-2-3-4, press and hold in the code set button,
press 1- 2-3-4, then channel " I", pause
te econd, then press channel " I '` again.
3. If your coding has been successful, you will notice a flash from one of the lights on
the receiver board to confirm that your code is now stored in memory.
4. Release the code set button on the opener.
5. Test your P.I.N with the correct channel number.
6. Move to the next opener you wish to program and again press and hold in the code set
button.
7. Press a four digit P.I.N and immediately press the channel you wish to transmit on.
For example, you may wish to open your garage door on channel 2. You would then
press 5-6-7-8 , then press channel "2" twice.
8. Again, if you have been successful, you will receive a confirmation flash from the
light on the receiver control board or the opener .
For assistance with code programming , please contact ATA on (03) 9532 2788