b) Replace oil and oil filter
•
Stop the engine, take down the drain bolt on the engine bottom, drain the oil when the
engine body is warm, and fill about 2.8 liters of new oil.
•
Start engine and make it run 5 minutes, check oil level after engine has stopped running
for at least 3 minutes.
c) Replace oil filter
•
Unscrew the oil filter anticlockwise using a special wrench, and then take down it.
•
Clean the mounting surface of oil filter using a cleaning cloth.
•
Apply a little oil on the rubber washer of the new oil filter.
DO NOT UNSCREW DRAIN PLUG WHEN ENGINE IS HOT OR SERIOUS INJURY MAY
•
Screw oil filter with hand until the washer comes into contact with mounting surface.
•
Screw three-quarter circle more with wrench after contact point.
•
Add transmission gear oil.
•
The specified transmission gear oil is No.18 synthetic dual curve gear oil.
WARNING!!!
OCCUR DUE TO HOT OIL.
91