Download Print this page

Argent EURA Care & Installation Manual

Basin mixers

Advertisement

Quick Links

EURA
BASIN MIXERS
NOTES PRIOR TO INSTALLATION
1. INSPECT ALL PARTS PRIOR TO INSTALLATION FOR
SUITABILITY AND/ OR DEFECTS
2. ANY SUSPECTED DEFECT SHOULD BE REPORTED AS
SOON AS POSSIBLE
3. SHOULD ANY PRODUCT BE INSTALLED DESPITE A FAULT
HAVING BEEN FOUND AND REPORTED, ARGENT WILL
NOT ACCEPT LIABILITY FOR THE COST OF LABOUR TO
REMOVE AND INSTALL ANY REPLACEMENT PRODUCT/S
NOTES FOR INSTALLATION
1. Please ensure pipework is clear of debris by flushing
lines prior to installation.
2. We recommend hot and cold water isolation stops are
used – not included in supply.
PRESSURE AND TEMPERATURE REQUIREMENTS
1. Inlet pressure range 100 – 500kpa
2. Maximum hot water temperature 60 C
3. AS/NZS 3500 requires 500 kPa maximum operating
pressure at any outlet within a building
4. Hot & Cold inlets should have equalised water
pressures.
STEP 1
• Where the mixer is going into a stone or
laminate top, cut a 35mm ø hole.
Technical Hotline
1800 356 717
STEP 2
• Install the allthread screw into the
bottom of the basin mixer.
• Install basin mixer sealing O ring &
flange(if supplied)
Customer Central
1300 364 748
Eura Basin Mixers
Care & Installation Guide
21008
ASNZ 3718
Please direct any
feedback for this product
to Customer Central:
support@customer-
central.com.au or call
1300 364 748
support@customer-central.com.au

Advertisement

loading
Need help?

Need help?

Do you have a question about the EURA and is the answer not in the manual?

Questions and answers

Summary of Contents for Argent EURA

  • Page 1 2. ANY SUSPECTED DEFECT SHOULD BE REPORTED AS SOON AS POSSIBLE 3. SHOULD ANY PRODUCT BE INSTALLED DESPITE A FAULT HAVING BEEN FOUND AND REPORTED, ARGENT WILL NOT ACCEPT LIABILITY FOR THE COST OF LABOUR TO REMOVE AND INSTALL ANY REPLACEMENT PRODUCT/S NOTES FOR INSTALLATION 1.
  • Page 2 EURA Eura Basin Mixers Care & Installation Guide BASIN MIXERS STEP 3 STEP 4 • Feed the two hoses through the hole in • Fit the rubber gasket and fixing plate the basin or bench top and attach to into position under the basin/ bench the basin mixer.