Advertisement
❼ Replace the fuse (#28) and test the Power
Twin II, one leg at a time. Check to see that the
switches are wired in a logical relationship (UP
position on the switch will raise the jack leg, DOWN
position lower the jack leg).
EMERGENCY HANDLE
USAGE/MANUAL OPERATION
❶ Remove the fuses from the fuse holders.
❷ Remove the four (4) bolts (ITEM# 24) holding
the motor in place.
❸ Place the pinned collar drive on the handle
over the slotted collar and turn the crank the
appropriate direction to either extend the Power
Twin II leg or retract it.
ULTRA POWER TWIN II-30
ULTRA POWER TWIN II-22
INSTRUCTIONS FOR USE
TRAVEL TRAILER OR 5
❶ Chock your wheels and level your RV from
front to back by using your tongue jack or landing
gear.
❷ Using a level, determine which side of our RV
is the lowest and extend the jack(s) on that side
until your RV is level.
❸ Extend the jack(s) on the opposite side of the
RV until they touch the ground firmly. Your RV is
now in its most stable position.
❹ You
can
retract
simultaneously.
CLASS C MOTOR HOMES
❶ Set your brakes.
❷ Extend the jack on the low side of your Class
C motor home until the rear is level.
❸ Extend the opposite side until it touches the
ground firmly. Your RV is now in its most stable
position.
CAUTION:
ALWAYS RETRACT POWER TWIN II
BEFORE DEPARTING.
LUBRICATION
Each motor/gear assembly should be re‐greased once
per year through the grease fitting on the gearbox.
WARNING: DO NOT USE pneumatic‐powered lube
equipment as it can damage the leveler unit. Use
hand‐operated grease gun only.
Two pumps of chassis lube once per year is all that
should be required. DO NOT over fill the gearbox with
chassis lube as it could push into the motor causing
damage to the motor.
P/N 39-941705
P/N 39-941707
REV 12/2013
TH
WHEELS
all
of
the
jacks
Advertisement
