Pacific GSM DIN-3G Instructions Manual

Pacific GSM company expanded its range of DIN mounted
communicators for DIN-3G version of popular GSM DIN dialler
GSM-DIN3. The new DIN-3G available in 230V AC, 110V AC,
and also low 8-25V AC or DC version, so any electrical
application can be quickly and easily switched or monitored
through 3G network.
Through DIN-3G communicator can be remotely controlled
such as lighting, pumps, garage doors and gates.
May indicate a fault, loss of liquid in tanks, emergency conditions,
reboot servers or simply using a suitable sensor watch
objects, spaces and objects.
All easily through standard mobile phone
DIN-3G module is a fully pre-programmed, for most common
function (alarm report), just call the unit SIM number from phone
which you want to contact if a DIN-3G input 1 connected to GND,
DIN-3G will send you confirmation SMS with saved number and
that is all. Furthermore, the protocol allows you to edit text, switching commands, and settings of maximum
adaptation to your application. The options are twofold: either via USB-PC or SMS commands, please refer
manual below

Basic specification:

• DIN-3G communicator dimensions: 90 x 68 x 58 mm (H x W x D)
• UMTS 800/ 850/ 900/ 1900/ 2100 MHz
• GSM/EDGE 850/ 900/ 1800/ 1900 MHz
• Power supply voltage: 230V AC
• The communicator is backed up by internal Li-ion battery 3.7 V/550mAh
• Current consumption – communicator connected to network: approx. 20 mA, relays on 120mA, battery charging 320mA
Max current consumption (GSM module transmits): peak of 1500mA max.
•
• Operating temperature: -20°C to +50°C
2 logic inputs, active level GND.
•
Input is designed for connection of potential-free contacts!
• 1 input for digital temperature sensor with a measuring, range from -20°C to 125°C.
(Temperature sensor sold separately with cable length 2m,3m and 5m)
• 2 relay outputs 230V with load max 5A
• USB-PC configuration with USB cable (cable include in package)
• DIN-3G is designed in a dry environment. For outdoor installation, use the box with corresponding protection.
• 6 authorized phone numbers can be set up

Basic Features:

• Two universal inputs with adjustable reaction to change, connection or disconnection of the loop.
• Inputs can be named (SMS text).
• Each input can send 2 different TXT for remote status equipments
• Inputs can be use for arming/disarming the communicator from remote device
• Inputs option for entry and exit time
• In case it is necessary to have an input permanently enabled (the watchdog state), can be switched into mode 24h. loop.
• Input for digital temperature sensor with automatic output control (thermostat).
• Information SMS in case of exceeding the set temperature or the temperature drops below the set limit.
• Device Status, you can always check the status via SMS.
• Easy configuration USB-PC software or SMS commands
DIN-3G
3G Network Communicator
Instructions: July 5, 2017, refers to the firmware version: 1.152N