Raymarine SmartPilot X-Series Setup Manual page 14

8
ST6002 Controllers
1 Press and hold standby for two seconds
to enter the Calibration mode
2 When the screen shows DISPLAY CAL,
press disp until you see the DEALER CAL
screen
3 Press auto: the display will change to CAL
4 Simultaneously press -1 and +1 to enter
Dealer calibration mode
Note:
For more information on settings and calibration modes, refer to
tem settings
At the CAL screen, press
3. In Dealer calibration, access the vessel type screen, using disp if necessary. The
vessel type screen shows either VESSEL or one of the vessel types (DISPLACE,
SEMI DISPLACE, PLANING, STERN DRV, WORK BOAT or SAIL BOAT).
Setting vessel type
The vessel type setting automatically determines appropriate default values for
various other calibration settings. Some of these settings are checked later in this
procedure and others should not require any adjustment. The default values for each
vessel type are listed on page 35 .
Set the vessel type as follows:
1. Use -1 or +1, or the rotary control to set the appropriate vessel type, as in the
following table.
Type
DISPLACE
SEMI DISPLACE
PLANING
STERN DRV
.
Description
Power-driven boats which do not plane
(Typically below 15 kts top speed)
Faster power-driven boats which do not plane
(Typically 15-20 kts top speed)
Planing boats with inboard engine(s) and shaft drives
(NOT boats with outdrives)
Boats with outdrives or outboard engines
SmartPilot X-Series Commissioning & Setup Guide
ST7002 and ST8002 Controllers
1 Press and hold standby for two seconds to
enter the Calibration mode
2 When the screen shows DISPLAY CAL,
disp
press
you see the DEALER CAL screen
3 Press auto: the display will change to CAL
4 Simultaneously press -1 and +1 (on the
ST7002) or the up and down arrows (on the
ST8002), to enter Dealer calibration mode
+ together to enter DEALER CAL
-1 +1
or
+
(ST8002 only)
or the up and down arrows, until
Chapter 2: SPX sys-
D10746-1