Charging The Battery Pack - Sony CCD-TR57 Operating Instructions (primary manual) Operating Instructions Manual

Installing and charging the battery pack

Charging the battery pack

Charge the battery pack on a flat surface without vibration. The battery pack is charged
a little in the factory.
(1) Open the DC IN jack cover and connect the supplied AC power adaptor to the
DC IN jack with the plug's 4 mark up.
(2) Connect the power cord to the AC power adaptor.
(3) Connect the power cord to a wall outlet.
(4) Slide the POWER switch to OFF. Remaining battery time is indicated by the
minutes on the display window. Charging begins.
When the remaining battery indicator becomes ı, normal charge is completed. For
full charge, which allows you to use the battery longer than usual, leave the battery
pack attached for about 1 hour after normal charge is completed until FULL appears in
the display window.
Before using the camcorder with the battery pack, unplug the AC power adaptor from
the DC IN jack of the camcorder. You can also use the battery pack before it is
completely charged.
POWER
CAMERA
OFF
Notes
•"--- min" appears on the display until the camcorder calculates remaining battery
time.
•Remaining battery time indication in the display window roughly indicates the
recording time. Use it as a guide. It may differ from the actual recording time.
8
VTR