Advertisement
Installing the adapter kit
Note: If you are installing a 7" T3 touch screen, you must
install the back and the front adapter plates. If you are
installing a 10" T3 touch screen, the front adapter plate
is optional.
To attach the back adapter plate and power box:
1 If necessary, use a cutting tool to remove any plastic in the
wall box that may interfere with mounting the T3 touch
screen's power box.
2 Place the back adapter plate on top of the wall box, then
attach it to the wall box using the two screws that were used
to hold the old touch screen in place.
3 Determine whether you need to attach the front adapter
plate.
If you are installing a 7" touch screen, you must install the
front adapter plate to conceal the wall box tabs.
If you are installing a 10" touch screen, install the front
adapter plate only if you want to conceal the wall box tabs
when viewing the screen from the side.
10" touch screen
without front
adapter plate
2
4 To attach the front adapter plate (optional), place it over the
5 Follow the installation instructions in the T3 In-Wall Touch
6 Insert the power box into the adapter plate, then use the
7 Attach the new T3 In-Wall Touch Screen to the power box.
10" touch screen
with front
adapter plate
Note: If you attach the front adapter plate, the wall box's
top and bottom tabs will be concealed, but at the cost
of offsetting the touch screen further from the wall.
back adapter plate.
Screen Installation Guide (
ctrl4.co/iw-ig
power or PoE connections to the T3 power box. The use of
AC power or PoE depends on your installation requirements.
screws that came with the T3 In-Wall Touch Screen to secure
the power box into the adapter plate(s).
- OR -
Caution! Hand tighten the screws with very little torque.
Over-tightening the screws will drive the power box too
deep into the adapter plate and will either (1) break the
plastic tabs on the power box or (2) misalign the power
box such that the touch screen will not attach to the
power box correctly.
) to attach the AC
Advertisement
