Control 4 C4-7ZTOT3 Installation Manual

T3 In-Wall Touch Screen
Adapter Kit for
7" Wall-Mount Touch
Screen

Installation Guide

Supported touch screen models
• C4-WALL7-xx 7" In-Wall Touch Screen
• C4-WALL10-xx 10" In-Wall Touch Screen
Supported adapter kit models
• C4-7ZTOT3 Adapter Kit for 7" Wall-Mount Touch Screen
(C4-TSWM7/Zykronix) to T3 Touch Screen

General description

This Control4® adapter kit provides an adapter plate to
accommodate the installation of a T3 In-Wall Touch Screen. The
kit is intended for an existing C4-TSWM7 (Zykronix) touch screen
to be replaced by a T3 In-Wall Touch Screen.
Optional
• Tools to modify the wall box, such as a tape measure, a
pencil, a Phillips screwdriver, a small saw to cut heavy plastic,
a utility knife, or a handheld rotary cutting tool.
What's in the kit
• Back adapter plate
• Front adapter plate
• Two screws for power box installation
• T3 In-Wall Touch Screen Adapter Kit for 7" Wall-Mount Touch
Screen Installation Guide (this document)

Before starting

Important: Instead of using an adapter kit, we
recommend that, wherever possible, you entirely
remove the old touch screen's wall box, repair the wall,
then install the T3 In-Wall Touch Screen's wall box as
designed.
Important: The front adapter plate will be easily
visible with the 7" screen. For the most even finish, we
recommend painting the adapter plate to match the wall
before attaching it to the wall box.
1 1
Removing the original touch screen
To remove the original touch screen:
1 Press up on the top center of the bezel until it unclips from
the touch screen.
2 Press outward on the two sides of the bezel until they unclip
from the touch screen, then unclip the bottom of the bezel.
3 Remove the two screws that hold the touch screen to the
wall box, and keep the screws for use later in the procedure.
4 Pull the touch screen away from the wall box, disconnect the
wires that connect to the touch screen (including Ethernet, if
present), then completely remove the touch screen.