Step 3: Connecting The Audio Cords - Sony BDP - S1 Operating Instructions Manual

Step 3: Connecting the
Audio Cords
Select the connection that best suits your system. Be sure to read
the instructions for the components you wish to connect.
Connection
A
TV
B
Stereo amplifier (receiver) and
two speakers
C
AV amplifier (receiver) having a
*1
Dolby Surround (Pro Logic)
decoder and 3 to 6 speakers
• Surround effects: Dolby Surround
(Pro Logic)
D-1
AV amplifier (receiver) with
5.1ch input jacks and 6 speakers
• Surround effects: Dolby Digital
(5.1ch), DTS (5.1ch)
D-2
AV amplifier (receiver) with a
digital input jack having a Dolby
*2
Digital or DTS decoder and 6
speakers
• Surround effects: Dolby Digital
(5.1ch), DTS (5.1ch)
D-3
AV amplifier (receiver) with an
HDMI input jack and 8 speakers
• Surround effects: 8ch Linear
PCM
*1
Manufactured under license from Dolby laboratories.
"Dolby," "Pro Logic," and the double-D symbol are trademarks of
Dolby Laboratories.
*2
"DTS" and "DTS Digital Surround" are registered trademarks of
Digital Theater Systems, Inc.
Notes about the HDMI OUT jack
• When you connect the player to an AV amplifier (receiver)
using an HDMI cord, you will need to do one of the following:
– Connect the AV amplifier (receiver) to a TV with the HDMI
cord.
– Connect the player to the TV with a video cord other than
HDMI cord (component video cord, S VIDEO cord, or video
cord).
• When connecting to the HDMI OUT jack, carefully align the
HDMI connector with the jack. Do not bend or apply pressure
to the HDMI cord.
• If you change the component connected to the HDMI OUT
Your setup
jack, change the "Audio (HDMI)" in "Audio Setup" to match
the new component (page 47). The player stores the HDMI
related settings for up to five components.
• The HDMI connection is compatible with 2ch Linear PCM
signals (48 to 192 kHz, 16/20/24 bit), and 6 to 8ch Linear PCM
signals (48 to 96 kHz, 16/20/24 bit), in addition to Dolby
Digital and DTS bit stream (5.1ch signals up to 96 kHz, 16/20/
24bit).
Note
If you connect a component that does not conform to the selected audio
signal, a loud noise (or no sound) will come out from the speakers, which
could damage your ears or speakers.

Step 3: Connecting the Audio Cords

,continued
13